Tips When Troubleshooting the Cause of Your Garage Door Not Opening

17 February 2016
 Categories: , Blog


If you push the button on your garage door remote and notice that your door is not opening, this can be a major issue. You need for your garage door to open and close with the push of a button to ensure that you can get your vehicle in and out of your garage with ease. Once you notice that the garage door will not open, you need to begin troubleshooting what the cause of the problem could be. Before you can have your garage door or remote repaired, you need to be aware of the most helpful troubleshooting tips that allow you to identify the cause of the problem.   

Mode

It is always a good idea to check and see what mode your garage door is in. If it is in lock mode, this will result in it not opening when you push the button on the remote from the outside of your garage. When it is in this type of mode, you will have to unlock the garage door by using the control that is present on the wall inside the garage. You could have put your garage door into lock mode by accident, which will result in your garage door remote not working correctly until you rest it.

Battery

It is also a good idea for you to check the battery within your garage door remote. You can check the battery by moving into the garage while holding the remote. Make sure that you press the button on the remote and look to see if there is a small light that is flashing on the box of the garage door system. The box is typically positioned near the chains at the bottom of the door. If you notice that the door will only open when you are near the box, you can be sure that the battery is beginning to fail. Changing the battery within the remote should correct the problem.

Wires

It is also possible that one of the wires on the control box could be lose, which is causing your garage door to not open when you use the remote. You can determine if this is the cause of the problem by using the remote and moving each wire one by one as you hit the open button on the garage remote. If moving one of the wires slightly causes the door to open, you can know that the wire is lose, which is causing the remote to not function properly. Make sure that you determine which wire is loose and then tighten that wire.


Share